Navigation

Universal Reverb dr...
 
Notifications
Clear all

Universal Reverb driver wired between preamp and power


Tomtweed
(@tomtweed)
New Member
Blev medlem: 1 månad sedan
Inlägg: 2
Topic starter  

Hello Moody makers. I apologize in advance for only speaking English. Let me say the universal reverb driver is brilliant! I build small tube amps and am able to do some amp repairs.

Is there a wiring diagram for wiring the universal driver in a circuit? For example in between the pre-amp and power section?

Thank you in advance.

Tom


Citera
moody
(@mastermoderator)
Medlem Admin
Blev medlem: 3 år sedan
Inlägg: 9
 

Hello, I am glad you like the pedal. No, we have not written a wiring diagram for making it a part of another circuit. But it should be fairly simple to connect it. You want to skip the footswitch S1, the LED and the jacks? Connect incoming signal directly to the hole "in" on the PCB and signal going out directly to "out". The input signal level should be below 1V or so. And you will have to connect DC 9V to the +v in and ground it.

The LED is not needed as well as the serier resistor R35. If you know the input impedance of your tank there are other cmponents on the board you can skip. For instance, if you are using the c out for your tank, you can skip the sections around T3, T4, T5 and the trafo. If you are using the trafo out, you can skip the section around T2. 


SvaraCitera
Tomtweed
(@tomtweed)
New Member
Blev medlem: 1 månad sedan
Inlägg: 2
Topic starter  

Thank Moody. That is soooo very helpful. This is going to be a fun project. I have a few small amps that will be perfect for this application.

I will post my efforts, when I get around to it.

Tom


SvaraCitera