moodysounds forum

Hi there The voltage at the collectors of T4 and T5 should be around 8V5 so with your measurement that the push pull output is saturated and c...

Hi there, Oh and You wire the Treble control like this take a wire from N2 to terminal 3 of Treble control. Terminal 3 is the terminal t...

Hi there, If you use the suggested values 22nF (0,022uF) and 2K0 and 50KC and I believe you can easily get those parts in NYC and you wir...

Hi There George, And a happy new year to you I think what you'd like to do is much easierly done with Bone Bender 1 since you would al...

@martialsound Hi there, No not really But if anything is unclear just ask. At your service Bjorn

Hi there Mike, By all means. Yes you can just remove T3 and the switch is outof the circuit Note that you can alter the time constant as in ...

Pleased to meet you Rey Bjorn

Hi there Mobyoctopad, To answer your question Fuzz 66 yes you can because it is a Fuzz Face inspired by a youtube of a particular red Fuzz Face....

Hi there Rasmus, The transformer output is a push-pull power amp and T4,T5 are powertransistors driving the transformer. Trimmer TR1 sets the re...

Hi There Peter It does seem the input transformer in reverbtank could be shorted. I have had one tank do that and it was caused by a metal flan...

Hi there Pter Ah yes my misstake then and as I said above measure output of transfomer under load and you will see... Are you sure tank is...

Hi there Peter, With Oscilliscope you can measure output at secondary of transformer under load and if you have a sine generator you'll see where ma...

Hi Peter, The transformer output is made to drive 8 Ohm tanks so yes it might be too low for 100 Ohm tanks. Ideally if you can find you'd need...

Hi there gents I’ll combine answers below Hej Björn (and others on the forum too)! I had an attempt at building the Universal Reverb kit...