@cmchaney06 I'll keep you in the loop with the mods. When I did the first build, I thought that volume drop was an error on my part. I think it was ...

@bjf Hey Bjorn, Thanks for your response. To clarify, you said 'the 1K5 resistor goes from DW1 to terminal 2 on Dwell pot ( that is middle termi...

@bjf Hi Bjorn, Thanks for your previous instructions. I made the modifications you recommended: R4 to 2k2, R7 to 110k, R8 to 47k, C5 to 15n, C3 t...

@bjf Just checking back. I've double checked the pot values, and replaced one capacitor I thought might have been the issue. No luck so far. Any ...

@bjm Thanks for that...I really appreciate it. I've even tried changing a couple resistors that I thought might have been the issue, but no luck so...

@bjm I tried adding a 10M ohm resistor, which raised the resting voltage of T1 to 2.7. The volume loss issue was still present. I also noticed ...

@bjm Thanks for your reply...yes, still having the same issue with volume loss past 3 oclock on Dwell 1. I can wire the resistor if you think it wi...

@bjf Hey Bjorn, I did some more testing of components to see if I can find the problem. I saw on an earlier post that resting voltage on T1 and the...

@bjm Thanks Bjorn. Sorry I if wasn't clear...I'm still having the same issue--basically that the output of the pedal drops in volume after 3 o'...

@bjf I went back to check that reading, and the blue output cable is saying 0 now--must have been touching another component. Thanks, Mike

@bjf Thanks so much for the reply....I appreciate the help. I checked the voltages of the output on the board (blue wire solder point that says out...

@bjf see previous comment.....forgot to tag you in the last one. Thanks!

Hi, I've recently built the universal reverb driver.....it seems to work great, but I find that that dwell 1 keeps a consistent output volume up to ...